This system is about coupling different power systems with a reverse osmosis desalination plant. User can switch between Solar Thermal Power and Solar electrical PV power. For the solar thermal part, the following units are considered:
1-Solar Molten Salt PTC (Parabolic Trough Collector) and/or CST (Concentrated Solar Tower).
2-Boiler heat exchanger unit with two storage sections (hot & cold).
3-Pump (Molten Salt).
5-Condenser cooling tower unit.
6-Water steam is for the power cycle and Molten Salt is for the solar part.
The solar electrical part is modeled based on the Photovoltaic system. User will be able to collect some data such as:
2-Module and cell area.
3-Open circuit voltage and short circuit current.
For the reverse osmosis part, the user can select between different systems combined with RO.
-The steam table is considered.
-Cost analysis is performed.
-Molten salt properties are considered.
**MatLab-SimuLink (64bit) should be used to run the model.
Copyright © 2007 by Mohamed A. Sharaf Eldean Ayoub
All rights reserved. No part of this work may be reproduced, distributed, or transmitted in any form or by any means, including photocopying, recording, or other electronic or mechanical methods, without the prior written permission of the publisher (Mohamed A. Sharaf Eldean Ayoub). For permission requests, write to the publisher, addressed “Attention: Permissions Coordinator,” at the address below.
REDS Software Library
Kuala Lumpur Malaysia
All Rights Reserved
Concentrated Solar Power and Photovoltaic for Reverse Osmosis Desalination Plant
You can get your discount code from the services page, or ask for it via chatting with Prof Dr. Mohamed A Sharaf Eldean.