This model is about Concentrated Solar Tower (CST) for power generation by the use of Gas Turbine Cycle (GTC) Regeneration with different working gases. Users can assign the grid needed power. The load power from the user is mainly supplied from the GTC. In order to obtain all design aspects such as:
1-Design aspects for GTC.
2-Energy and Exergy streams are calculated.
3-Working fluid mass flow rate through the cycle.
All cycles are prepared for dynamic and fixed-point modeling. All cycles are designed for electric power generation. Users can change the working fluid by assigning the specific heat capacity of the selected gas type. Users can switch between solar and gas-fired combustion chamber. The cycle contains the following:
1-Low pressure compressor.
2-Intercooler.
3-High pressure compressor.
4-Heat exchanger.
5-Combustion chamber I (CST) solar tower.
6-High pressure turbine.
7-Combustion chamber II (CST) solar tower.
8-Low pressure turbine.
9-The exhaust from the Low-pressure turbine will be used as a power source for the Organic Rankine Cycle (ORC=3 working fluids). The ORC contains:
1-BHX for thermal power.
2-Turbine.
3-Recuperator.
4-Condenser.
5-Pump.
3 working fluids are considered for the ORC.

**MatLab-SimuLink should be used to run the model.
Copyright © 2007 by Mohamed A. Sharaf Eldean Ayoub
All rights reserved. No part of this work may be reproduced, distributed, or transmitted in any form or by any means, including photocopying, recording, or other electronic or mechanical methods, without the prior written permission of the publisher (Mohamed A. Sharaf Eldean Ayoub). For permission requests, write to the publisher, addressed “Attention: Permissions Coordinator,” at the address below.
 
REDS Software Library
https://www.redslibrary.com
Kuala Lumpur Malaysia
mohamedsheraf@redslibrary.com
00601139795943
All Rights Reserved
___________________