This model is about desalination and power genergation by the use of concentrated solar tower system (CST) combined with MEDpf configuration. User can assign the production rate of fresh water in order to obtain all design aspects such as:
1-CST field design (area, No. of mirrors, tower height, etc..).
2-Design aspects for steam Rankine cycle.
3-All operating conditions and design limits for MEDpf.
4-Cost analysis are considered.
5-Energy, Exergy, and thermo-economic streams are calculated.
6-Molten salt heat transfer fluid is used through the CST.
7-Water steam is used for steam Rankine cycle.
8-Boiler heat exchanger-Storage unit is used as an intermidiate unit.
9-Single storage with embedded pump unit is used.
All cycles are prepared for dynamic and fixed point modeling. All cycles are designed for
desalination and electric power generation.
**Watch the video:
**MatLab-SimuLink should be used to run the model.
email us for the password (firstname.lastname@example.org)
Copyright © 2007 by Mohamed A. Sharaf Eldean Ayoub
All rights reserved. No part of this work may be reproduced, distributed, or transmitted in any form or by any means, including photocopying, recording, or other electronic or mechanical methods, without the prior written permission of the publisher (Mohamed A. Sharaf Eldean Ayoub). For permission requests, write to the publisher, addressed “Attention: Permissions Coordinator,” at the address below.
REDS Software Library
Kuala Lumpur Malaysia
All Rights Reserved
Concentrated Solar Tower for MEDpf Desalination and Power Generation
User has the ability to reform the model based on his need. Dynamic modeling is allowed.