In this Evacuated tube Solar Collector (ETC) design model with Therminol-VP1 heat transfer oil is attached to PCM storage tank. The system is used to generate hot steam via flash evaporation tank. User will be able to discover the total area based on the assigned thermal load volume. The following paramters can be calculated:
1-Mean plate temperature.
2-ETC total area.
3-Overall losses.
4-Efficiency.
5-exergy analysis.The system main units are:
1-ETC.
2-PCM storage.
3-Oil pump.
4-Flash evaporation tank.
5-Water pump unit.** Watch the model video:
**MatLab-SimuLink should be used to run the model.
Copyright © 2007 by Mohamed A. Sharaf Eldean AyoubAll rights reserved. No part of this work may be reproduced, distributed, or transmitted in any form or by any means, including photocopying, recording, or other electronic or mechanical methods, without the prior written permission of the publisher (Mohamed A. Sharaf Eldean Ayoub). For permission requests,
write to the publisher, addressed “Attention: Permissions Coordinator,” at the address below.
REDS Software Library
https://www.redslibrary.com
Kuala Lumpur Malaysia
mohamedsheraf@redslibrary.com
00601139795943
All Rights Reserved
___________________
Evacuated Solar Collector (PCM/Flash/PV) for Steam Generation
User can reform the model based on his need. Dynamic modeling is allowed.