This design model is about Evacuated Tube Solar Collector (ETC-Water working fluid) for the heating load. The system design is attached to an intermediate heat exchanger storage tank. The system is used to generate thermal heat based on the user load.
Users will be able to discover the total area based on the assigned thermal load volume. The following parameters can be calculated:
1-Mean plate temperature.
2-ETC total area.
3-Overall losses.
4-Efficiency.
5-Exergy analysis.
6-System total thermal power.
7-Total system area, design operating conditions, and flow rates.
8-Storage tank design and size.
9-Cost analysis.The system main units are:
1-ETC.
2-Heat exchanger storage tank.
4-Pumping system.
5-Load.
6-Water working fluid.
**MatLab-SimuLink should be used to run the model.
Copyright © 2007 by Mohamed A. Sharaf Eldean Ayoub
All rights reserved. No part of this work may be reproduced, distributed, or transmitted in any form or by any means, including photocopying, recording, or other electronic or mechanical methods, without the prior written permission of the publisher (Mohamed A. Sharaf Eldean Ayoub). For permission requests, write to the publisher, addressed “Attention: Permissions Coordinator,” at the address below.
REDS Software Library
https://www.redslibrary.com
Kuala Lumpur Malaysia
mohamedsheraf@redslibrary.com
00601139795943
All Rights Reserved
___________________
Evacuated Tube Collector for Thermal Heat Load: Design Model
You can get your discount code from the services page, or ask for it via chatting with Prof Dr. Mohamed A Sharaf Eldean.