This model is about gas solids separator unit. Cyclone Separators are most commonly used equipment for the separation of dust particles from an air/gas stream is the cyclone separator. The dust-laden gas stream enters near the top of the collection chamber tangentially. The force on the larger particles is greater than the force on the smaller ones because the latter particles have less mass and therefore spiral downward into the dust hopper. When the gas velocity is not sufficient to suspend the particles, gravity causes the particles to fall into the dust collection chamber. Further, a small-diameter cyclone generates a greater centrifugal force than a large diameter unit. User will discover all design aspects for this device.
**Watch the video:
https://youtu.be/Vp0hW2nrB0c
 
**MatLab-SimuLink should be used to run the model.
Copyright © 2007 by Mohamed A. Sharaf Eldean Ayoub
All rights reserved. 
No part of this work may be reproduced, distributed, or transmitted in any form or by any means, including photocopying, recording, or other electronic or mechanical methods, without the prior written permission of the publisher (Mohamed A. Sharaf Eldean Ayoub). 
For permission requests, write to the publisher, addressed “Attention: Permissions Coordinator,” at the address below.
 
 
REDS Software Library
https://www.redslibrary.com
Kuala Lumpur Malaysia
mohamedsheraf@redslibrary.com
00601139795943
 
All Rights Reserved
___________________