This model is about power genergation by the use of Gas Turbine Cycle (GTC) with Air working gas. User can assign the grid needed power The load power from user is mainly supplied from the GTC. In order to obtain all design aspects such as:
1-Design aspects for GTC.
2-Energy, and Exergy streams are calculated.
3-Air fluid is used through the GTC.
All cycles are prepared for dynamic and fixed point modeling. All cycles are designed for electric power generation.
**MatLab-SimuLink should be used to run the model.
Copyright © 2007 by Mohamed A. Sharaf Eldean Ayoub
All rights reserved. No part of this work may be reproduced, distributed, or transmitted in any form or by any means, including photocopying, recording, or other electronic or mechanical methods, without the prior written permission of the publisher (Mohamed A. Sharaf Eldean Ayoub). For permission requests, write to the publisher, addressed “Attention: Permissions Coordinator,” at the address below.
REDS Software Library
Kuala Lumpur Malaysia
All Rights Reserved
Gas Turbine Cycle for Power Generation (Air Basic Design Model)
You can get your discount code from services page, or ask for it via chatting with
Prof Dr Mohamed A Sharaf Eldean.