This model is about power generation by the use of Gas Turbine Cycle (GTC) Regeneration with different working gases (user can assign any Cp, kJ/kg of any gas type). Users can assign the grid needed power The load power from the user is mainly supplied from the GTC. In order to obtain all design aspects such as:1-Design aspects for GTC.2-Air fluid is used through the GTC.All cycles are prepared for dynamic and fixed-point modeling. All cycles are designed for electric power generation. The cycle contains the following:1-Low pressure compressor.2-Intercooler.3-High pressure compressor.4-Heat exchanger.5-Combustion chamber I.6-High pressure turbine.7-Combustion chamber II.8-Low pressure turbine. **MatLab-SimuLink should be used to run the model. Copyright © 2007 by Mohamed A. Sharaf Eldean AyoubAll rights reserved. No part of this work may be reproduced, distributed, or transmitted in any form or by any means, including photocopying, recording, or other electronic or mechanical methods, without the prior written permission of the publisher (Mohamed A. Sharaf Eldean Ayoub). For permission requests, write to the publisher, addressed “Attention: Permissions Coordinator,” at the address below. REDS Software Libraryhttps://www.redslibrary.comKuala Lumpur Malaysiamohamedsheraf@redslibrary.com00601139795943All Rights Reserved___________________