This system is about coupling different power systems with a reverse osmosis desalination plant. User can switch between Solar Thermal Power and other systems such as Solar electrical PV, Horizontal Axis Wind Turbine, Vertical Axis Wind Turbine, Fuel Cell+PV, Diesel Generator, and Main Grid power. For the solar thermal part, the following units are considered:
1-Solar Molten Salt PTC (Parabolic Trough Collector) and/or CST (Concentrated Solar Tower).
2-Boiler heat exchanger unit with two storage sections (hot & cold).
3-Pump (Molten Salt).
4-Turbine unit.
5-Condenser cooling tower unit.
6-Water steam is for the power cycle and Molten Salt is for the solar part.
The electrical parts (PV, HWT, VWT, DG) are modeled based on sizing, cost, and design. User will be able to collect some data such as:
1-Design area.
2-Module and cell area.
3-Open circuit voltage and short circuit current.
4-Costs
etc...
For the reverse osmosis part, the user can select between different systems combined with RO. RO types:
1. RO-Basic
2. RO-PWT
3. RO-PEX
-The steam table is considered.
-Cost analysis is performed.
-Molten salt properties are considered.
 
**MatLab-SimuLink (64bit) should be used to run the model.
Copyright © 2007 by Mohamed A. Sharaf Eldean Ayoub
All rights reserved. No part of this work may be reproduced, distributed, or transmitted in any form or by any means, including photocopying, recording, or other electronic or mechanical methods, without the prior written permission of the publisher (Mohamed A. Sharaf Eldean Ayoub). For permission requests, write to the publisher, addressed “Attention: Permissions Coordinator,” at the address below.
 
REDS Software Library
https://www.redslibrary.com
Kuala Lumpur Malaysia
mohamedsheraf@redslibrary.com
00601139795943
All Rights Reserved
___________________