In this Parabolic Trough Solar Collector (PTC) design model with Therminol-VP1 heat transfer oil is attached to PCM storage tank. The system is used to generate hot steam via flash evaporation tank. User will be able to discover the total area based on the assigned thermal load volume. The following paramters can be calculated:
1-Mean plate temperature.
2-PTC total area.
The system main units are:
4-Flash evaporation tank.
5-Water pump unit.
**MatLab-SimuLink should be used to run the model.
Copyright © 2007 by Mohamed A. Sharaf Eldean Ayoub
All rights reserved. No part of this work may be reproduced, distributed, or transmitted in any form or by any means, including photocopying, recording, or other electronic or mechanical methods, without the prior written permission of the publisher (Mohamed A. Sharaf Eldean Ayoub). For permission requests,
write to the publisher, addressed “Attention: Permissions Coordinator,” at the address below.
REDS Software Library
Kuala Lumpur Malaysia
All Rights Reserved
Parabolic Trough Solar Collector (PCM/Flash/PV) for Steam Generation
User can reform the model based on his need. Dynamic modeling is allowed.