This model is about a design model for the single effect evaporation powered by mechanical vapor compression for seawater desalination. Photovoltaic solar power has been connected to power on the mechanical vapor compressor and the pumps. The plant includes the following:
1-Single effect evaporation.
2-Mechanical vapor compression.
3-Distillate/Feed preheater (plate heat exchanger).
4-Brine/Feed preheater (Plate heat exchanger).
5-Photovoltaic power plant.
6-Exergy & Cost Analysis.
The system is in design mode. Som the users will be able to calculate the size, areas, flow rates, pressures, cost, etc...
**MatLab-SimuLink (64bit R2016a up to R2021a) should be used to run the model.
Copyright © 2007 by Mohamed A. Sharaf Eldean Ayoub
All rights reserved.
No part of this work may be reproduced, distributed, or transmitted in any form or by any means, including photocopying, recording, or other electronic or mechanical methods, without the prior written permission of the publisher (Mohamed A. Sharaf Eldean Ayoub).
For permission requests, write to the publisher, addressed “Attention: Permissions Coordinator,” at the address below.
REDS Software Library
https://www.redslibrary.com
Kuala Lumpur Malaysia
mohamedsheraf@redslibrary.com
00601139795943
All Rights Reserved
___________________
Single Effect Mechanical Vapor Compression Assisted by Photovoltaic Solar Power
You can get your discount code from the services page, or ask for it via chatting with Prof Dr. Mohamed A Sharaf Eldean.