This model is about solar thermal power for MSFbr desalination plant. Solar PTC is conencted to the MSFbr via Heat evaporator unit (BHX). Therminol-VP1 is used as a working fluid though the BHX and solar PTC. Water steam is used for MSF brine heater unit.
In this sub-Model:
1. User should specify the ambient temperature in degree Celsius.
2. Also plant productivity should be specified (Md, m3/day).
3. Outlet collector temperature, oC (max not exceeding above 400oC for HTO).Not that:
For PTC collector the design operating temperature shouldn't exceed above 400oC.
MSF-BR desalination plant. User should assign the following:
1-Sea water temperature oC.
2-Top brine temperature oC.
3-Brine blowdown temperature oC.
4-Feed seawter 1st splitter ratio.
5-Seawater and brine blowdown salinity ratios kg/kg.
6-Number of stages.
7-Tubes diameter for each section m.
8-Pumps efficiency 0.00.
**MatLab-SimuLink (64bit) should be used to run the model.email us for the password (msherafeldin@gmail.com)
Copyright © 2007 by Mohamed A. Sharaf Eldean Ayoub
All rights reserved. No part of this work may be reproduced, distributed, or transmitted in any form or by any means, including photocopying, recording, or other electronic or mechanical methods, without the prior written permission of the publisher (Mohamed A. Sharaf Eldean Ayoub). For permission requests, write to the publisher, addressed “Attention: Permissions Coordinator,” at the address below.
Suez University, Suez Egypt
Faculty of Petroleum & Mining Engineering
Egineering Science Dept
mohammed.eldeen@suezuniv.edu.eg, mwahab31@yahoo.com
00601139795943All Rights Reserved
___________________
Solar Thermal for MSFbr Desalination Process
User can reform the model based on his need. Dynamic model is allowed.